![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
To All:
I don't know the current price of new, stock heads. Air-cooled VW heads are made by VW de Mexico. San Diego prices are influenced by our proximity to the border. NEW, stock, POPULATED heads -- meaning it's ready to run -- was about $125, last time I checked. Bare heads -- no valves, springs, retainers, keepers, guides nor seats... as little as $50. IF ...you've got all the tools, know how to twirl the knobs and the head does NOT require any welding, an old head can be rebuilt for as little as $15 and 2 man-hours. From there, the price goes up. Labor is the biggie but it's going to fall as the depression deepens. Those of us with VW engines are going to make out rather well over the next few years; the numbers are in our favor when it comes to the cost of repair & maintenance. -Bob |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
A Preliminary Assessment of the Potential Cost and Cost-Effectiveness of Space-Based Weapons. | Mike[_7_] | Naval Aviation | 0 | November 2nd 07 03:18 PM |
Ball Valve,Needle Valve,Snubber,Gauge Cock Sale on good price | valvetom | Piloting | 0 | November 28th 06 02:32 AM |
Brass Ball Valve,Gas Valve,Needle Valve,Angle Valve,Hose Bibcock Sale on good price | valvetom | Piloting | 0 | November 28th 06 02:25 AM |
sticky valve or | Dick | Home Built | 18 | May 25th 05 07:50 PM |