|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 24th 10, 01:49 AM
posted to rec.aviation.soaring
|
|||
|
|||
LS1 Tail locking spring
"Andrew" wrote in message ... It is avery expensive solution to replace a piece of wire. I haven't seen the part in question, but if it is truly just a length of spring wire, I would pay a visit to my local 2-way radio shop and rummage in the box where they throw the old car antenna whips. You might just find some LS1 parts there... Vaughn 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Winpilot pro and Ipaq 4700 locking up. | joesimmers | Soaring | 5 | July 17th 08 05:42 AM |
| 90 degree locking pliers? | B. Jensen | Home Built | 8 | October 3rd 05 06:50 PM |
| New Wheel Locking Device | TM | Products | 2 | March 29th 05 04:07 PM |
| Looking for 3/8 in-24 thread/low profile self locking nuts/ | Larry | Home Built | 3 | February 22nd 05 03:02 PM |
| FS: Blanik L-13 Tail Skid & Tail Wheel Assembly | Tim Hanke | Soaring | 0 | February 8th 05 01:34 PM |
Hybrid Mode
