|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 12th 13, 11:29 PM
posted to rec.aviation.soaring
|
|||
|
|||
Grob drop off tail dolly
On Wednesday, June 12, 2013 8:04:13 AM UTC-7, Greg Delp wrote:
Did the one you make have a wheel or wheels on the tow bar portion? That sounds like a good alternative.If the tow bar portion was strong enough to prevent any leaning of the post section it would evenly distribute all the stress along the entire wall of the socket in the tail. Greg, The tow bar I made just attatches to the axle of the origninal 'Wheel-on-a-post'. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Grob 103 Tail Dolly | Roger Fowler[_2_] | Soaring | 3 | September 1st 10 02:21 AM |
| Wanted: Tail Dolly for Grob 102 Club III | Mitch Deutsch | Soaring | 2 | May 4th 10 09:05 PM |
| LS4 tail dolly | Leigh | Soaring | 0 | May 30th 08 02:02 AM |
| WTB: used tail dolly | David Campbell | Soaring | 5 | April 17th 06 03:19 PM |
| L-23 tail dolly | Mark Zivley | Soaring | 1 | November 27th 04 11:16 AM |
Hybrid Mode
