![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
![]()
Which denatured alcohol did you use? Be sure to use at least 90%. Second, mask off the area that will be taped and lightly sand with 1000 or 1500 grit wet sandpaper. Sand just enough to dull the surface.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
LS4 aileron gap seal and mylar seal width | Eric Foertsch | Soaring | 8 | May 18th 17 07:50 PM |
EE Lightning Prep | Bill[_18_] | Aviation Photos | 0 | November 18th 08 08:51 PM |
The party prep is done... | Jay Honeck | Piloting | 0 | July 19th 05 04:24 PM |
Teflon gap seal tape... | Marc Ramsey | Soaring | 10 | April 3rd 05 04:35 PM |
Solvent save for markings | chris | Soaring | 2 | January 22nd 04 12:35 AM |