If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
O200 first run
Hello,
I just try to run my new overhauled engine with TAF-L oil filter modification.. Oil pump is new. I primed the oil pump, I oiled all the engine with an external GM V8 oil pump throug the TAF-L inlet (6 qts), I checked the oil poured at the oil pressure sensor hole before start. And when I start the engine, no oil pressure after 1mn30s run. I appreciate any indication... thanks -- Philippe Vessaire Ò¿Ó¬ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
C85 and O200 piston | Philippe[_4_] | Home Built | 2 | August 11th 10 05:47 PM |
O200 overhaul | Philippe[_4_] | Home Built | 0 | May 30th 10 08:38 PM |
O200 cylinder | Philippe Vessaire[_3_] | Home Built | 3 | October 19th 08 11:21 AM |
O200 engine | Philippe Vessaire | Home Built | 7 | August 17th 07 08:53 PM |
O200 nose | Philippe | Home Built | 0 | July 22nd 05 08:09 PM |