|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
May 9th 16, 04:32 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm with FlarmView, I have a question.
On Monday, May 9, 2016 at 8:16:44 AM UTC-7, David Kinsell wrote:
The bigger question is how well your PF is handling your Mode C transponder? It has trouble filtering out your own transmissions, may want to consider upgrading to Mode S for best results. I assume you have Aggressive filtering selected, and you are receiving Mode C? Using aggressive filtering and a Trig TT22 that's being interrogated by Mode C. The flashing blue dot is boring. Until checking the "use TXP altitude" box, every pull-up brought a collision warning. This is my second PowerFLARM used in conjunction with Mode S. The previous installation of PF with Trig TT21 wasn't a problem. But that might have been using better FLARM firmware? Jim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flarmview and Powerflarm Core Config File? | Papa3[_2_] | Soaring | 4 | May 18th 15 10:51 PM |
| Borgelt B50 and PowerFLARM Question | Paul Remde | Soaring | 5 | May 13th 15 08:48 PM |
| Question about PowerFlarm IGC recording rate | SoaringXCellence | Soaring | 5 | June 6th 13 11:51 PM |
| Stupid PowerFLARM Question | Peter von Tresckow | Soaring | 9 | March 1st 12 11:50 AM |
| PowerFLARM Mode S question | kirk.stant | Soaring | 54 | October 26th 10 02:51 PM |
Threaded Mode