|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 6th 03, 03:36 PM
|
|||
|
|||
WANTED: 12 inch dia Spinner for homebuilt.
WANTED: 12 inch dia Spinner for homebuilt. Cherokee 150 style to fit Lycoming 0-320 with Sensenich metal prop would be ideal. CONTACT: n863wl at yahoo dot com 
|
|
#2
August 6th 03, 03:50 PM
|
|||
|
|||
|
Make up your mind which one's your email... Got two 6-inch diameter
spinners, I'm sure you can make them fit. chuckle "Barnyard BOb --" wrote in message ... WANTED: 12 inch dia Spinner for homebuilt. Cherokee 150 style to fit Lycoming 0-320 with Sensenich metal prop would be ideal. CONTACT: n863wl at yahoo dot com
|
|
#3
August 7th 03, 05:33 AM
|
|||
|
|||
|
"Barnyard BOb --" wrote in message ... WANTED: 12 inch dia Spinner for homebuilt. Cherokee 150 style to fit Lycoming 0-320 with Sensenich metal prop would be ideal. CONTACT: n863wl at yahoo dot com http://cgi.ebay.com/ebaymotors/ws/eB...tegory=26 439
|
|
#4
August 7th 03, 05:57 PM
|
|||
|
|||
|
tom c wrote:
/snip/ http://cgi.ebay.com/ebaymotors/ws/eB...tegory=26 439 Bob, Note that the above referenced prop *will not* work with your Sensenich, it only fits on the ******* little McCauley 152 prop. Happy Flying! Scott Skylane
|
|
#5
August 8th 03, 01:01 AM
|
|||
|
|||
|
Scott Skylane wrote: tom c wrote: /snip/ http://cgi.ebay.com/ebaymotors/ws/eB...tegory=26 439 Bob, Note that the above referenced prop *will not* work with your Sensenich, it only fits on the ******* little McCauley 152 prop. Happy Flying! Scott Skylane ++++++++++++++++++++++++++++++++++++++ Thanks for the heads up, Scott. From the pix I could see it wouldn't work... but, I did wonder what it was designed to fit. The Cherokee 150 bullet style or maybe even a Beech Mouseketeer would do for my application. Nothing from Cezzna appears to be applicable. P.S. I also need both bulkheads to go with the spinner. Bob --
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spinner paint scheme | Dick | Home Built | 3 | January 27th 05 09:58 PM |
| spinner trimming technique | Dick | Home Built | 0 | January 25th 05 11:57 PM |
| striped spinner | Pianome | Home Built | 1 | July 4th 04 09:56 PM |
| spinner fab | Dick | Home Built | 5 | April 23rd 04 02:26 AM |
| NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | Home Built | 4 | March 11th 04 11:31 PM |
Hybrid Mode
