|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
January 15th 20, 04:19 PM
posted to rec.aviation.soaring
|
|||
|
|||
ventus c main wheel mudguard attachment
On Monday, January 13, 2020 at 10:29:53 AM UTC-5, Martynas Bykovas wrote:
Hello, i plan to install mudguard on main wheel. I have mudguard itself but it is not clear how/what it should be exactly attached to. I found wheel including mudguard drawings for cirrus however i doubt there is the same attachment principle for ventus c. I would be grateful if someone could share wheel/suspension/mudguard drawings or pics. BR, Martynas While you are fooling with the mudguard be sure to check the locknuts on the overcenter limit bolts. I had a forced gear up landing with my Ventus CM several weeks ago because a loose locknut allowed the limit bolt to vibrate out about 1/8 in which was enough to prevent the handle to reach the detent.Fortunately I had a thick grass runway so no damage. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WTB - used Cleveland 40-78B main wheel | Roy B. | Soaring | 1 | February 19th 18 08:25 PM |
| Ventus 2C main wheel inner tube. Short stem or long stem valve ? | [email protected] | Soaring | 1 | July 1st 14 06:07 AM |
| ASW-24 Main Wheel Removal | Lauren Rezac | Soaring | 5 | March 19th 12 04:20 PM |
| Glider Main Wheel Dolly | Jim[_18_] | Soaring | 0 | March 9th 11 04:19 PM |
| main wheel dollies, plans? | [email protected] | Soaring | 1 | July 18th 07 06:55 AM |
Threaded Mode