|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 22nd 08, 11:25 AM
posted to rec.aviation.soaring
|
|||
|
|||
Monokote trim patches for covering holes - not recommended
On Sun, 20 Jul 2008 09:11:33 -0700, Uncle Fuzzy wrote:
Pretty sure it's 'unobtainium' now. I could be mis-remembering, but I think I used Hexane as an additive to fuel for my compression ignition engines. That would have been ether, assuming you mean model engines: 40% ether, 20% castor oil, 39% kerosene, 1% amyl nitrate runs pretty well. Outside a lab I've only seen hexane sold as thinners for Evostik contact cement. -- martin@ | Martin Gregorie gregorie. | org | Zappa fan & glider pilot 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Covering holes | [email protected] | Soaring | 9 | May 2nd 08 05:57 PM |
| Going of ver recommended TBO | gman | Piloting | 10 | October 11th 06 05:52 AM |
| Covering an ultralight wing with Monokote | Chris Wells | Home Built | 5 | January 10th 06 12:20 AM |
| When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 01:19 AM |
| Anywhere recommended near Rochester MN? | Dave | Aerobatics | 0 | April 1st 04 05:18 PM |
Hybrid Mode
